Directions for Use

Preparing the Surface:
All surfaces must be clean and free from debris. Always test product in an inconspicuous area for suitability.

Surfaces:
When properly applied SureSeal's Graffiti Shield will protect cementitious surfaces, masonry, stucco, sandstone, stone monuments, metal, wood, painted, and unpainted surfaces.

Directions for Application:
Begin application at the highest point of the surface to be treated. Completely wet the surface by applying SureSeal's Graffiti Shield with a paint brush, roller, SureSeal Pump Sprayer or airless sprayer. When treating rough or textured surfaces a pump or airless sprayer is recommended. Apply one coat evenly, thoroughly saturating the surface being treated. Allow at least one hour drying time, for optimum protection, surface should be allowed 24 hours curing time.

Maintenance:
To remove graffiti from treated areas, clean with a warm water pressure washer with a pressure of up to 1200 PSI. Do not use harsh cleaning agents such as abrasive powders, ammonia, acids, bleach, solvents or abrasive scrubbing pads. After removing graffiti, allow surface to dry. For maximum protection, re-apply one coat of SureSeal's Graffiti Shield to the affected area.

Coverage: Up to 600 – 1500 square feet per gallon. Coverage is approximate and will vary depending on the surface being treated and the applicator.

Note: Consult the SureSeal Graffiti Shield Material Safety Data Sheet for details regarding Hazardous Properties and Personal Protective Equipment requirements.

SureSeal USA © 2005 | Privacy Policy | Terms Of Use