24/7 Stone Impregnator

Non-flammable, environmentally friendly, water-based impregnator that is used as a superior impregnator/sealer on all types of stone (including sandstone, limestone, terra cotta, brick, concrete, etc) and to help prevent oil and water-based staining. Resists staining from gum. Will not whiten, puddle, flake, peel or discolour while allowing treated surface to breathe. UV light resistant. For both indoor and outdoor use.

Installation:
Always ensure that the surface is clean and free from debris and previous sealants and waxes. Any existing stains must be removed prior to sealant application. Apply by brush, roller or garden-type sprayer. One good coat is normally sufficient. However, on very porous surfaces or heavy walkway areas, two coats are recommended. Allow five hours between application of each coat. Normal drying time on marble or granite is approximately 20 minutes. However, buff before completely dry.

Maintenance:
On outdoor surfaces, use a garden hose with a pressure nozzle or pressure washer with a pressure of up to 1200 PSI (be careful not to etch surface). Do not use harsh cleaning agents such as abrasive powders, ammonia, acids, bleach, solvents or abrasive scrubbing pads.

Tech Data

Sure Seal® 24/7 Stone Impregnator (water based)

UN No:

None Allocated

Hazchem:

None Allocated

Appearance:

Amber liquid with a slightly pungent odor.

Boiling Point:

100 - 102°C

Flash Point:

No flashpoint from 20°C to the boiling point 100 - 102°C (in the test conditions)

Solubility in Water:

Soluble

Quantities:

Supplied in 5 litre containers (4 x 5 litres to a carton), 20 litre drums

SureSeal USA © 2005 | Privacy Policy | Terms Of Use